How to Attach a Flashlight Holder to a Plate Carrier

By Archangel Tactical - Archangel Tactical Gear | Published: 2026-10-28

Category: How-to Guides

Learn how to mount a flashlight holder to a plate carrier using MOLLE webbing. Step-by-step instructions for a secure, accessible light setup.

Quick Answer

Attach your flashlight holder to a plate carrier by weaving the MOLLE straps through the webbing, then securing the flashlight in the pouch. Choose a spot that keeps the light within easy reach without interfering with your gear.

Choose the Right Mounting Spot

Before you start, think about where on the plate carrier you want the flashlight. A common choice is the front or side webbing, where you can grab it with either hand. Avoid placing it where it will be blocked by a magazine pouch or other gear you use often. The holder should sit flat against the carrier so it doesn't snag on brush or equipment.

Also consider the size of your flashlight. The Archangel Tactical Flashlight Holder fits tubes up to about 1.2 inches in diameter and flashlights longer than 5 inches, thanks to its stretchy nylon and open ends. If your light is larger, it may not fit securely.

Step-by-Step: Mounting Your Flashlight Holder

Step 1: Position the Holder: Place the flashlight holder against the MOLLE webbing on your plate carrier in your chosen spot. Make sure the open ends point up and down (or forward and backward) so the light slides in and out easily. Check that the holder isn't blocking any pouches you use frequently.
Step 2: Weave the MOLLE Straps: Thread the holder's MOLLE straps through the webbing on the carrier, starting from the back and pulling through to the front. Weave the straps in an over-under pattern to lock the holder in place, then pull them tight and secure the ends (usually with a snap or Velcro). Make sure the straps are fully seated and not twisted, or the holder may shift during movement.
Step 3: Insert the Flashlight: Slide the flashlight into the holder from the open end. Adjust the 360-degree clip to angle the light where you want it, and ensure the light is seated firmly so it doesn't rattle or fall out when you move. Test the draw: you should be able to pull the light out quickly with one hand, but it should stay put when you run or bend.

Flashlight Holder That Works with MOLLE

Flashlight Holder - Archangel Tactical Gear: This adjustable holder has a 360-degree rotatable clip and fits flashlights with a tube diameter up to 1.2 inches and a length over 5 inches. The rotatable clip lets you angle the light where you need it, and the open-ended stretchy nylon keeps the light snug without blocking the beam.
Flashlight Holder - Archangel Tactical Gear